Step 3. Press the release tab toward the handle and carefully pull the handle at the same time to slide the
hot-swap power supply out of the chassis.
Notes: Slightly pull the power supply upwards when sliding the power supply out of the chassis, if
you have installed one of the following CMA kits:
• 1U CMA Upgrade Kit for Toolless Slide Rail
• Toolless Slide Rail Kit with 1U CMA
Figure 65. Hot-swap power supply removal
After removing the power supply:
• Install a power supply filler or a new power supply to cover the power supply bay.
Important: To ensure proper cooling during normal server operation, both of the power supply bays must
be occupied. This means that each bay must have a power supply installed; or one has a power supply
installed and the other has a power supply filler installed.
• If you are instructed to return the old power supply, follow all packaging instructions and use any
packaging materials that are provided.
102
ThinkSystem SR530 Maintenance Manual
To Next Page
Loading...
