Each hot-swap drive has two LEDs.
Drive LED
Status
Description
8 Drive status LED (right)
Solid yellow The drive has an error.
Blinking yellow (blinking slowly, about
one flash per second)
The drive is being rebuilt.
Blinking yellow (blinking rapidly,
about four flashes per second)
The RAID controller is locating the
drive.
9 Drive activity LED (left)
Solid green The drive is powered but not active.
Blinking green The drive is active.
Operator information panel
The operator information panel of the server provides controls and LEDs.
The following illustration shows the operator information panel of the server.
Figure 6. Operator information panel
Table 4. Components on the operator information panel
Callout Callout
1 Power button with power status 2 Network activity
3 System ID button with ID 4 System error
1 Power button with power status
You can press the power button to power on the server when you finish setting up the server. You also can
hold the power button for several seconds to power off the server if you cannot shut down the server from
the operating system. The power status helps you to determine the current power status.
Status Color
Description
Solid on Green
The server is on and running.
Slow blinking
(about one flash
per second)
Green The server is off and is ready to be powered on (standby state).
Fast blinking
(about four flashes
per second)
Green The server is off, but the XClarity Controller is initializing, and the server is
not ready to be powered on.
Off
None There is no ac power applied to the server.
Chapter 2. Server components 19
To Next Page
Loading...
