LOM adapter replacement
Use this information to remove and install the LOM adapter.
Remove the LOM adapter
Use this information to remove the LOM adapter.
“Read the
installation
Guidelines” on
page 45
“Power off
the server
for this task”
on page 14
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before removing the LOM adapter:
1. Remove the top cover. See “Remove the top cover” on page 57.
2. If riser 1 assembly is installed, remove it to access the LOM adapter slot.
To remove the LOM adapter, complete the following steps:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku: http://list.youku.com/albumlist/show/id_50437162
Figure 90. LOM adapter removal
Step 1. Loosen the thumbscrew that secures the LOM adapter.
Step 2. Push the LOM adapter out of the connector on the system board.
Step 3. Slide the LOM adapter as shown and lift the LOM adapter out of the chassis.
If you are instructed to return the old LOM adapter, follow all packaging instructions and use any packaging
materials that are provided.
124
ThinkSystem SR530 Maintenance Manual
To Next Page
Loading...
