Backplanes
Use this section to understand the cable routing for the backplanes.
Server model with eight 2.5-inch hot-swap drives
Use this section to understand the internal cable routing for the server model with eight 2.5-inch hot-swap
drives.
The following illustration shows the cable routing for the server model with eight 2.5-inch hot-swap drives.
Figure 17. Cable routing for the server model with eight 2.5-inch hot-swap drives
Cable From To
1 Power cable Power connector on the backplane Backplane power connector on the system board
2 SAS signal
cable
SAS 0 and SAS 1 connectors on the
backplane
C0 and C1 connectors on the HBA/RAID adapter
Chapter 2. Server components 37
To Next Page
Loading...
