Hot-swap power supply replacement
Use this information to remove and install the hot-swap power supply.
Remove a hot-swap power supply
Use this information to remove a hot-swap power supply.
“Read the
installation
Guidelines” on
page 45
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
S035
CAUTION:
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage,
current, and energy levels are present inside any component that has this label attached. There are no
serviceable parts inside these components. If you suspect a problem with one of these parts, contact
a service technician.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S001
98 ThinkSystem SR530 Maintenance Manual
To Next Page
Loading...
