Step 2. If the server is in a rack, adjust the CMA to gain access to the power supply bay.
If you have installed the 1U CMA Upgrade Kit for Toolless Slide Rail or Toolless Slide Rail Kit with
1U CMA, do the following:
Figure 67. CMA adjustment
a. Press down the stop bracket 1 and rotate it to the open position.
b. Rotate the CMA out of the way to gain access to the power supply bay.
Step 3. If there is a power supply filler installed, remove it.
Figure 68. Hot-swap power supply filler removal
106 ThinkSystem SR530 Maintenance Manual
To Next Page
Loading...
