6 USB 3.0 connectors (2)
Attach a USB-compatible device, such as a USB keyboard, USB mouse, or USB storage device.
7 VGA connector
Used to attach a high-performance monitor, a direct-drive monitor, or other devices that use a VGA
connector.
8 Ethernet connector 2
9 Ethernet connector 1
Used to attach an Ethernet cable for a LAN. Each Ethernet connector has two status LEDs to help you
identify the Ethernet connectivity and activity. For information about the LEDs, see “Rear view LEDs” on page
25.
Ethernet connector 1 can be set as XClarity Controller Network connector. To set Ethernet connector 1 as
XClarity Controller Network connector, start Setup utility, go to BMC Settings ➙ Network Settings ➙
Network Interface Port and select Shared. Then, go to Shared NIC on and select Onboard Port 1.
10 XClarity Controller network connector
Used to attach an Ethernet cable to manage the system using XClarity Controller.
11 Ethernet connector 2 on the LOM adapter
12 Ethernet connector 1 on the LOM adapter
The LOM adapter provides two extra Ethernet connectors for network connections.
Ethernet connector 1 on the LOM adapter can be set as XClarity Controller Network connector. To set the
Ethernet connector as XClarity Controller Network connector, start Setup utility, go to BMC Settings ➙
Network Settings ➙ Network Interface Port and select Shared. Then, go to Shared NIC on and select
PHY Card.
24
ThinkSystem SR530 Maintenance Manual
To Next Page
Loading...
