Remove the LCD diagnostics panel assembly
Use this information to remove the LCD diagnostics panel assembly.
About this task
Attention:
• Read “Installation guidelines” on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 220.
Step 2. If the security bezel is installed, remove it. See “Remove the security bezel” on page 203.
Step 3. Remove the LCD diagnostics panel assembly from the chassis.
Figure 57. LCD diagnostics panel assembly removal
a. Press down the extended tab on the other side of the front chassis.
b. Slide the assembly out of the front chassis.
118
ThinkSystem SR630 V2 Maintenance Manual
To Next Page
Loading...
