Step 4. Install the RAID super capacitor module on the chassis.
Figure 119. Installation of the RAID super capacitor module on the chassis
a. Open the retention clip on the holder.
b. Put the RAID super capacitor module into the holder and press it down to secure it into the
holder.
After you finish
1. Connect the super capacitor module to an adapter with the extension cable that comes with the super
capacitor module. See “RAID super capacitor modules” on page 60.
2. Complete the parts replacement. See “Complete the parts replacement” on page 224.
Remove the RAID super capacitor module on the air baffle
Use this information to remove the RAID super capacitor module on the air baffle.
About this task
Attention:
• Read “Installation guidelines” on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
194 ThinkSystem SR630 V2 Maintenance Manual
To Next Page
Loading...
