Step 4. Position the riser assembly on the chassis. Align the plastic clip and two pins on the bracket with
the guide pin and two holes on the chassis and align the riser card with the riser slot on the system
board. Then, carefully press the riser assembly straight down into the slot until it is fully seated.
Figure 128. Riser assembly installation
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 224.
Security bezel replacement
Use this information to remove and install the security bezel.
Note: The security bezel is available on some models.
Remove the security bezel
Use this information to remove the security bezel.
About this task
Attention: Read “Installation guidelines” on page 83 to ensure that you work safely.
A video for this task is available at:
• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
Procedure
Chapter 4. Hardware replacement procedures 203
To Next Page
Loading...
