Step 3. Remove the M.2 module from the chassis.
Figure 90. M.2 module removal
a. Loosen the screw.
b. Release the M.2 adapter from the pin and carefully lift the M.2 adapter out from the chassis.
Step 4. Disconnect all M.2 cables from the system board.
After you finish
If you are instructed to return the old M.2 adapter or M.2 drive, follow all packaging instructions and use any
packaging materials that are provided.
Adjust the retainer on the M.2 adapter
Use this information to adjust the retainer on the M.2 adapter.
About this task
Attention:
• Read “Installation guidelines” on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
Procedure
168 ThinkSystem SR630 V2 Maintenance Manual
To Next Page
Loading...
