Step 2. Remove the drive filler from the drive bay and keep the drive filler in a safe place.
Figure 66. Drive filler removal
Step 3. Install the drive in the drive bay.
Figure 67. Hot-swap drive installation
a. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
b. Close the drive tray handle to lock the drive in place.
Step 4. Check the drive LEDs to verify that the drive is operating correctly. For details, see “Drive LEDs” on
page 25.
Step 5. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you have removed it. See “Install the security bezel” on page 204.
2. Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID if necessary. For more
information, see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_v3_about.html
Remove an EDSFF drive
Use this information to remove an EDSFF drive.
126 ThinkSystem SR630 V2 Maintenance Manual
To Next Page
Loading...
