b. Grasp the PCIe adapter by its edges and carefully pull it out of the PCIe adapter slot on the
riser card.
Note: The procedure for removing a PCIe adapter is similar for different types of riser assembly. In
this topic, the LP-FH riser assembly is used as an example.
After you finish
1. Install a PCIe adapter or PCIe adapter filler. See “Install a PCIe adapter” on page 175.
2. If you are instructed to return the old PCIe adapter, follow all packaging instructions and use any
packaging materials that are provided.
Install a PCIe adapter
Use this information to install a PCIe adapter.
About this task
Attention:
• Read “Installation guidelines” on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the PCIe adapter to any unpainted surface on
the outside of the server. Then, take the PCIe adapter out of the package and place it on a static-
protective surface.
Step 2. Locate the correct PCIe slot for the PCIe adapter. For information about the PCIe slots and
supported PCIe adapters, see “Rear view” on page 39.
Chapter 4. Hardware replacement procedures 175
To Next Page
Loading...
