System Environmental Information
Sub Menu
Example
• Ambient temperature
• Exhaust temperature
• PSU status
• Spinning speed of fans by RPM
Ambient Temp: 24 C
Exhaust Temp: 30 C
PSU1: Vin= 213 w
Inlet= 26 C
FAN1 Front: 21000 RPM
FAN2 Front: 21000 RPM
FAN3 Front: 21000 RPM
FAN4 Front: 21000 RPM
Active Sessions
Sub Menu
Example
Quantity of active sessions
Active User Sessions: 1
Actions
Sub Menu Example
Several quick actions are available:
• Restore XCC to Defaults
• Force XCC Reset
• Request XCC Reset
• Clear CMOS
• Request Virtual Reseat
• Modify XCC Static IPv4 Address/Net mask/Gateway
• Modify System Name
• Generate/Download FFDC Service Data
• Remove FPGA Test Image
Request XCC Reset?
This will request the BMC to reboot itself.
Hold √ for 3 seconds
Rear view
The rear view of the server varies by model. Depending on the model, your server might look slightly different
from the illustrations in this topic.
Refer to the following rear view for different server models:
• “Server model with three PCIe slots” on page 39
• “Server model with two PCIe slots” on page 40
• “Server model with two hot-swap 2.5-inch rear drive bays and one PCIe slot” on page 40
• “Server model with two hot-swap 7mm rear drive bays and two PCIe slots” on page 41
Server model with three PCIe slots
The following illustration shows the rear view of server model with three PCIe slots. Depending on the model,
your server might look slightly different from the illustration below.
Chapter 2. Server components 39
To Next Page
Loading...
