Lenovo thinksystem SR630 - Page 218

Step 1. Touch the static-protective package that contains the component to any unpainted surface on the
outside of the server. Then, take the component out of the package and place it on a static-
protective surface.
Step 2. Use a 5 mm wrench to install the serial port cable into the bracket.
Figure 137. Assembling the serial port module
Step 3. Install the serial port module to the riser bracket.
Figure 138. Installing the serial port module
Step 4. Install the riser assembly to the server.
Figure 139. Installing the riser assembly
Step 5. Connect the cable of the serial port module to the serial-port-module connector on the system
board. For the location of the serial-port-module connector, refer to “System board components”
on page 44.
208 ThinkSystem SR630 V2 Maintenance Manual