Cable routing with a CFF HBA/RAID adapter
The following table shows the mapping relationship between backplane connectors and adapter connectors
when a 16i CFF HBA/RAID adapter is installed.
Table 30. Mapping between backplane connectors and adapter connectors when a 16i CFF HBA/RAID adapter is
installed
Backplanes From To
Front BP (SAS) SAS 0 C0
SAS 1 C1
Rear BP (if any) SAS C3
Note: For power and input cable connection of the CFF HBA/RAID adapter, refer to “CFF HBA/RAID
adapter” on page 57.
The following figure illustrates the cable routing for the configuration of 8 x 2.5-inch front SAS/SATA drive
bays with a 16i CFF RAID adapter and a rear 2 x 2.5-inch SAS/SATA drive cage. Connections between
connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Figure 29. Cable routing for 8 x 2.5-inch front SAS/SATA drive bays with a 16i CFF RAID adapter and a rear 2 x 2.5-inch
SAS/SATA drive cage
Chapter 3. Internal cable routing 77
To Next Page
Loading...
