Lenze EMF2180IB - 3 Product Description; 3.1 Application as Directed

Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.1 EN · 09/2016 · TD17 11
3 Product description
3.1 Application as directed
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3 Product description
3.1 Application as directed
The communication module ...
• by remote maintenance is used for the parameterisation or programming, commissioning and
diagnostics of the applicable Lenze devices;
• is suitable
for the transmission of IEC61131 programs, application data (such as profile data)
and parameter data;
• is a device intended for use in industrial power systems;
• should only be used under the operating conditions prescribed in this documentation.
Simultaneous access from 2 PCs on the EMF2180IB communication module is not allowed.
Any other use shall be deemed inappropriate!
Application range
The communication module can be used with the following Lenze devices:
• Inverter of the i-series which are supporting CAN
• Inverter Drives 8400, 8400 motec, 8400 protec
• Servo Drives 9400
• 9300 servo inverter
• 9300 vector
• 9300 Servo PLC
• ECS servo system
• 8200 motec motor inverter
• 8200 vector frequency inverter
•Drive PLC
• 82XX frequency inverter
• starttec motor starter
• Terminal extension 9374
• Control / display unit (EPM-HXXX)
• I/O system IP20 (EPM-TXXX)