Lenze EMF2180IB - Page 39

Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.1 EN · 09/2016 · TD17 39
6 Commissioning
6.2 Commissioning with the web server
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The following function is available from version 1.7 onwards!
You can activate DHCP in the »Engineer« via code C1228
:
2180FEW018
So far, this has only been possible via a checkbox on the "TCP/IP Settings" page of the web interface.
A static IP configuration that has already been configured is maintained after the activation of
DHCP. Even after the deactivation of DHCP and
subsequent mains switching or reset, the static IP
configuration is still valid.