Lenze EPM-T1 Series - System bus (CAN) CANopen

System bus (CAN) / CANopen
Before switching on
11
Commissioning
11.1
11.1.1
L
11.1−1
EDSPM−TXXX−9.0−11/2009
11.1 System bus (CAN) / CANopen
11.1.1 Before switching on
Prior to supply voltage connection, check
l the wiring for completeness, short circuits and earth faults
l the wiring of the fieldbus
– A bus terminating resistor has to be connected to the first and the last
node.
l spatial cable separation from signalling and mains cables.
) Note!
After switching on the supply voltage, the modules of the I/O
system IP20 are initialised. During the initialisation, the modules
cannot be parameterised.
l Initialisation time − modular system: approx. 10 s
l Initialisation time − compact system: approx. 1 s