Lenze EPM-T1 Series - Loading default setting

12
Parameter setting via system bus (CAN) / CANopen
12.8
L
12.8−1
EDSPM−TXXX−9.0−11/2009
12.8 Loading default setting
Via index I2100
hex
all parameter changes are reset to the default setting. Changes
made by you are deleted from the EEPROM of the distributed I/O system.
Step Action Note
1. Loading factory setting Set index I2100
h
= 1
2. Reset Node Set index I2358
h
= 1 The changes are accepted.
3. Save changes Set index I2003
h
= 1