Lenze I95AE222F Mounting And Switch-On Instructions

Supply voltage c
onnecon
An external 24 V supply voltage to X5:24E/GE is necessary for supplying the control
electronics.
If the control electronics are supplied independently of the AC grid of the inverter, the inverter
can also be congured when the AC grid is turned o. Communicaon via exisng networks
also remains available.
DANGER!
Loss of the safe isolaon
Sa
fe isolaon of the control card from the mains potenal is deacvated when the motor and
motor holding brake are connected via a system cable AND X5 and X107 are supplied by a
common power supply unit. This also applies when using a SELV/PELV power supply unit.
Possible consequences: Electric shock in the event of a fault.
▶
Supply X107 and X5 by separate SELV/PELV power supply units if the motor and motor
holding brake are connected via a system cable.
24-V input
X5: 24E / GE
Use Input for mains-independent DC supply of the
c
ontrol electronics (incl. communicaon)
Input voltage DC
Typical V 24 IEC 61131-2
Area V 19.2 … 28.8
Input power
Typical W 20
Max. W 45 Depending on the use and state of inputs and
outputs.
Input current
Max. A 1.2
Peak A 2 For 50 ms when switching on
Capacity to be charged µF 5500
Polarity reversal pr
otecon When polarity is reversed: No funcon and no
irreparable damage.
Suppression of voltage pulses Suppressor diode 30 V, bidireconal
Power supply unit SELV/PELV Externally to create a mains-independent DC
supply.
Max. current A 12.0 While looping-through.
Electrical ins
tallaon
Supply voltage connecon
151

Lenze I95AE222F Specifications

General

Brand	Lenze
Model	I95AE222F
Category	Inverter
Language	English