EasyManuals Logo

Lenze I95AE222F Mounting And Switch-On Instructions

Lenze I95AE222F
Go to English
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #160 background imageLoading...
Page #160 background image
Funconal sa
fety
DANGER!
Improper ins
tallaon of the safety engineering system can cause an uncontrolled starng
acon of the drives.
Possible consequence: Death or severe injuries
Safety engineering systems may only be installed and commissioned by qualied personnel.
The complete wiring must be designed in accordance with EMC requirements.
All control components (switch, relay, PLC, ...) must comply with the requirements of
EN ISO 13849−1 and the EN ISO 13849−2.
Switches, relays with at least IP54 degree of protecon.
Always mount devices with a degree of protecon lower than IP54 in control cabinets with a
minimum degree of protecon of IP54.
The wiring must be shielded.
It is essenal to use insulated wire end ferrules for wiring.
All safety-relevant cables outside the control cabinet must be protected, e.g. by means of a
cable duct.
Ensure that no short circuits can occur according to the specicaons of the
EN ISO 13849−2.
All further requirements and measures can be obtained from the EN ISO 13849−1 and the
EN ISO 13849−2.
If an external force acts upon the drive axes, addional brakes are required. Please observe
that hanging loads are subject to the force of gravity!
For safety-related braking funcons, use safety-rated brakes only.
The user has to ensure that the inverter will only be used in its intended applicaon within
the specied environmental condions. This is the only way to comply with the declared
safety-related characteriscs.
DANGER!
Automac r
estart if the request of the safety funcon is deacvated.
Possible consequences: Death or severe injuries
You must provide external measures according to EN ISO 13849−1 which ensure that the
drive only restarts aer a conrmaon.
NOTICE
Overvoltage
Des
trucon of the safety component
Make sure that the maximum voltage (maximum rated) at the safe inputs does not exceed
30 V DC.
NOTICE
Excessively high humidity or c
ondensaon
Malfuncon or destrucon of the safety component
Only commission the safety component when it has acclimated.
Electrical ins
tallaon
Funconal safety
160

Table of Contents

Other manuals for Lenze I95AE222F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenze I95AE222F and is the answer not in the manual?

Lenze I95AE222F Specifications

General IconGeneral
BrandLenze
ModelI95AE222F
CategoryInverter
LanguageEnglish

Related product manuals