Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
13
2-5 INPUT SCREEN
Screen layout
11 A / a Press this key to switch capital letters to small letters, or vice versa
12 SHIFT
Press this key to access secondary characters on the key or the secondary
functions of group (3), (4), (8), (9) and (13).
13
PRINT
Press this key to move to the “PRINT” function.
FEED
(SHIFT → PRINT)
Press these keys to feed tubes or tapes.
14 Character keys Press these keys to input characters.
15 Press this key to change lines.
1 SHIFT Displays S when “SHIFT” is pressed, and it goes off when “SHIFT” is pressed again.
2 MEMORY Displays M when USB memory is inserted and when it is accessible.
3 A ,a
“A “is turned on. : Enables inputting capital letters
“a” is turned on. :Enables inputting small letters.
4 PRT/PITCH
In [PITCH PRINT MODE], display the “PITCH LENGTH.” (See 6-4: PITCH PRINT)
In [NORMAL PRINT MODE], displays the “PRINT LENGTH.”
(See 6-5: NORMAL PRINT)
5 PITCH CUT
Displays the way of the “PITCH CUTTING.” (See 6-4-2: PITCH CUT)
6 BLOCK No.
Displays the “BLOCK NO. “ on the cursor.
7 INPUT screen Displays the characters entered and the edit marks.
8 STATUS screen
The upper field displays the status of the sequential number if it has been set. The
lower field displays the printed material.
9 FRAME
Displays when the framing is “ON.” (See 6-9: FRAME)
10 VRT
Displays when the vertical printing is selected. (See 6-6: VERTICAL)
11 REPEAT
Displays the repeating numbers of the block on the cursor. (See 6-7: REPEAT)
12 C/SPACE
Displays character space. (See 6-3: CHARACTER LINE/SPACE)
13 C/WIDTH
Displays the character. (See 6-2: WIDTH)
14 C/SIZE
Displays the character size of the block on the cursor. (See 6-1: SIZE)
N
Ａ Ｂ Ｃ
P
Ｓ ▲ ２ ３ ． ８ Ｌ Ｉ Ｎ Ｅ ０ ０ ２
【 １ ０ 】 ０ ０ ０ １ － ０ ０ ０ ６
Ｔ Ｕ Ｂ Ｅ ３ ．６ ｍ ｍ
Ａ Ｕ Ｔ Ｏ Ｓ Ｔ Ｄ Ｓ Ｔ Ｄ ０ ０ ３ ▼ ▼
7
8
1
2
3
4 5 6
9
1112
13 1014
To Next Page
Loading...
Need help?
General
