Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
30
4-2-2 NORMAL PRINT ON THE TAPE
Printing the following contents on the tape.
MAX LETATWIN
LM-390A/PC
1. Set “MATERIAL=TAPE” and “SIZE=12mm” in the [PRINTED MATERIAL setting screen].
2. [INPUT screen] appears. Make sure that the arrow symbol “▲” is indicating “A” = capital letters.
Press / key to move the cursor to .
3. In order to change to [NORMAL PRINT MODE],
press
DELET to delete . (See 6-5: NORMAL
PRINT)
4. Press SHIFT → SIZE (TP/LNG) and set
“PRINTING LENGTH.” (See 6-5-1: Printing
length)
Press / key to select “AUTO=OFF.”
Then, press ▲ key to set the “LENGTH” and input
4 0 .
5. Press ENTER .
[MARGIN setting screen] appears.
Press ENTER .
▲ Ａ Ｕ Ｔ Ｏ Ｃ Ｕ Ｔ ０ ０ １
Ｔ Ａ Ｐ Ｅ １ ２ ｍ ｍ
３．０ ＳＴＤ ＳＴＤ ００１
［ Ｐ Ｒ Ｉ Ｎ Ｔ Ｉ Ｎ Ｇ Ｌ Ｅ Ｎ Ｇ Ｔ Ｈ ］
Ｌ Ｅ Ｎ Ｇ Ｔ Ｈ ＝ ４ ０ ｍ ｍ
Ａ Ｕ Ｔ Ｏ ＝ Ｏ Ｆ Ｆ
［ Ｍ Ａ Ｒ Ｇ Ｉ Ｎ ］
Ｌ Ｅ Ｆ Ｔ ＝ ２ ｍ ｍ
Ｒ Ｉ Ｇ Ｈ Ｔ ＝ ２ ｍ ｍ
Ｔ Ｏ Ｔ Ａ Ｌ ：
Ｌ Ｅ Ｓ Ｓ Ｔ Ｈ Ａ Ｎ ３ ４ ｍ ｍ
To Next Page
