Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
49
6-13-7 AUTO POWER-OFF
Setting the “AUTO POWER- OFF”.
After selecting the item by pressing / key, press ENTER to register the setting.
Note: When “YES” is selected, if no key is pressed for about 5 minutes, the machine turns off
automatically.
6-13-8 DEFAULT VALUE OF “PITCH LENGTH”
Setting the default value of “PITCH LENGTH.”
Note: The default value is set initially as “TUBE = 20mm and TAPE = 10mm” at our factory.
After setting the desirable value by pressing ▲/▼/ / key or Ten key,
press ENTER to register the setting.
Note：If you press the DELET , the value is initialized to the factory default value.
6-13-9 DEFAULT VALUE OF “REPEAT”
Setting the default value of “REPEAT.”
Note: The default value is set initially as “TUBE = 2pcs. and TAPE = 1pcs.” at our factory.
After setting the desirable value by pressing ▲/▼/ / key or Ten key,
press ENTER to register the setting.
Note：If you press the DELET , the value is initialized to the factory default value.
［ Ａ Ｕ Ｔ Ｏ Ｐ Ｏ Ｗ Ｅ Ｒ － Ｏ Ｆ Ｆ ］
Ｙ Ｅ Ｓ Ｎ Ｏ
Setting range：“Tube”＝10.0～60.0mm， “Tape”＝4.0～60.0mm
［ Ｐ Ｉ Ｔ Ｃ Ｈ Ｌ Ｅ Ｎ Ｇ Ｔ Ｈ ］
Ｔ Ｕ Ｂ Ｅ ＝ ２ ０ ． ０ ｍ ｍ
Ｔ Ａ Ｐ Ｅ ＝ １ ０ ． ０ ｍ ｍ
Setting range：1～100pcs.
［ Ｒ Ｅ Ｐ Ｅ Ａ Ｔ ］
Ｔ Ｕ Ｂ Ｅ ＝ ２ Ｐ Ｃ Ｓ
Ｔ Ａ Ｐ Ｅ ＝ １ Ｐ Ｃ Ｓ
To Next Page
