Letatwin MK9-USB - Printing on the Tape; Pitch Print on the Tape

Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
28
4-2 PRINTING ON THE TAPE
4-2-1 PITCH PRINT ON THE TAPE
Printing the following contents on the tape.
Tape size= 9mm Pitch length=15mm
U1
SLD SLD SLD SLD SLD SLD
COM COM
X18 X19 X1A X1B X1C X1D
15mm 15mm 15mm 15mm 15mm 15mm 15mm 15mm 15mm
1. Set “MATERIAL=TAPE” and “SIZE=9mm” in the [PRINTED MATERIAL setting screen].
2. [INPUT screen] appears. Make sure that the arrow symbol “▲” is indicating “A” = capital letters.
Press / key to move the cursor to .
3. Press PITCH to set “PITCH LENGTH.” (See
6-4-1: PITCH LENGTH) Press / key to set
“15.0.”
Press ENTER .
Note: It is also possible to input the value directly with
Ten key.
4. Press key to move the cursor after .
Input U 1 . Press BLOCK to create a new
block.
5. Input S L D , then X .
6. Press SEQ to set “SEQUENCE.”
(See 6-8: SEQUENCE)
Press / key to select “16 SCALE.”
▲ ２ ０ ．０ Ｌ Ｉ Ｎ Ｅ ０ ０ １
Ｐ Ｉ Ｔ Ｃ Ｈ Ｌ Ｅ Ｎ Ｇ Ｔ Ｈ
＝ １ ５ ． ０ ｍ ｍ
B
P
▲ １ ５ ．０ Ｌ Ｉ Ｎ Ｅ
０ ０ ２
Ｕ １
Ｔ Ａ Ｐ Ｅ ９ ｍ ｍ
ＡＵＴＯ ＳＴＤ ＳＴＤ ００１
B
P
B
１ Ｓ Ｌ Ｄ Ｘ
▲ １ ５ ．０ Ｌ Ｉ Ｎ Ｅ
０ ０ ２
Ｔ Ａ Ｐ Ｅ ９ ｍ ｍ
ＡＵＴＯ ＳＴＤ ＳＴＤ ００１
B
１ Ｓ Ｌ Ｄ Ｘ
▲ １ ５ ．０ Ｌ Ｉ Ｎ Ｅ
０ ０ ２
Ｓ Ｅ Ｑ Ｕ Ｅ Ｎ Ｃ Ｅ ＝
１ ６ Ｓ Ｃ Ａ Ｌ Ｅ
B