Letatwin MK9-USB - Justification; Printing Style of Rpt & Seq

Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
50
6-13-10 JUSTIFICATION
Setting the “JUSTIFICATION” for a document in the [NORMAL PRINT MODE].
Note: ● This setting is only applied to the [NORMAL PRINT MODE].
● The character arrangement in the [PITCH PRINT MODE] is always “CENTER.”
After selecting the item by pressing ▲/▼ key, press ENTER to register the setting.
6-13-11 PRINTING STYLE OF “RPT” & “SEQ”
Selecting the printing style for the “REPEAT and SEQUENCE”.
The default value of the “PRINTING STYLE” is “A : 11, 22, 33” at our factory.
When you use the “REPEAT and SEQUENCE” function at the same time, you can select the
printing style from “A : 11, 22, 33” or. “B : 123, 123.”
Example: REPEAT :2 pcs. SEQUENCE : 01～03
(A : １１，２２，３３)
01 01 02 02 03 03
(B : １２３，１２３)
01 02 03 01 02 03
1. Select the “PRINTING STYLE OF ｢RPT｣ & ｢SEQ｣” in the “OPTION” menu.
2. Press ▲/▼ to select the printing style.
Note：If you press the DELET key, the selection is initialized to the factory default.
3. Press ENTER key to register the new selection.
Selectable items: LEFT, CENTER, RIGHT
［ Ｊ Ｕ Ｓ Ｔ Ｉ Ｆ Ｉ Ｃ Ａ Ｔ Ｉ Ｏ Ｎ ］
Ｌ Ｅ Ｆ Ｔ
Ｃ Ｅ Ｎ Ｔ Ｅ Ｒ
Ｒ Ｉ Ｇ Ｈ Ｔ
［ Ｐ Ｒ Ｉ Ｎ Ｔ Ｉ Ｎ Ｇ Ｓ Ｔ Ｙ Ｌ Ｅ
Ｏ Ｆ “ Ｒ Ｐ Ｔ ” ＆ “ Ｓ Ｅ Ｑ ” ］
Ａ ： １ １ ， ２ ２ ， ３ ３
Ｂ ： １ ２ ３ ， １ ２ ３
( 2 pcs. )
( 2 pcs.)
Printed result
：
Printed result
：
COM
COM
COM
LEFT
CENTER
RIGHT
Example: