2-42 Lexmark™ E260d, E260dn
4513-220, -230
935.14 Printhead sweep error, fine sweep state
935.15 Printhead sweep error, check prelim amp state
935.16 Printhead sweep error, enable amp Kp state
935.17 Printhead sweep error, amp Kp failed to converge
935.18 Printhead sweep error, enable amp Ki state
935.19 Printhead sweep error, amp Ki failed to converge
935.20 Printhead sweep error, enable offset controller state
935.21 Printhead sweep error, load scan regs state
935.22 Printhead sweep error, fwd and rev capture times differ by too much
935.23 Printhead sweep error, check sweep accuracy state
935.24 Printhead sweep error, reserved
935.25 Printhead sweep error, detected resonant frequency out of expected range
935.26 Printhead sweep error, timed out waiting for end of sweep
Transport motor service errors
936.01 No lock detected at normal motor start
936.02 No lock detected at motor start for motor ID
936.03 No halls detected at motor start
936.04 Failed to stop within timeout
936.05 Stall detected during speed control
937.00 Main transport motor lost lock
937.01 Main transport motor lost lock, detected by engine control
937.02 Overspeed detected during position control
937.03 Overspeed detected during speed control
Power supply service errors
940.00 LVPS service error
940.01 Line frequency outside allowed range of 45Hz-64Hz
940.02 Line frequency below 43Hz
940.03 No zero cross detected on belt fuser model
Service error codes (9xx) (Continued)
Error Description