Diagnostic Aids 3-13
4022-XXX
Input Tray Tests
Input Tray Feed Test
The Feed Test operation within the INPUT TRAY TESTS menu is used by the
manufacturing line and service engineers to observe the paper path as media is being fed
through the printer. The top cover (used to access the print cartridge) cannot be opened
during the feed test. To observe the paper path, users must open the front door (used to
access the multipurpose feeder). No information is printed on the feed test pages since
the laser isn’t engaged during this test.
Note: The feed test can be run using any of the paper supported by the printer.
The pages are placed in the default output bin. However, the Feed Tests menu lets you
select the input source. Each of the installed sources is listed as an option within this
menu. For each source, the user has two choices:
• Single (feed one sheet of media),
• Continuous (continue feeding media until Return or Stop is pressed).
While the page is being fed, the following message is displayed. The Power indicator
blinks while the page is being fed.
If Single is selected, no buttons are active during the feed test. However, if Continuous is
selected, Return or Stop can be pressed to cancel the test. While the test is being
canceled, the following message is displayed.
Note: <input tray> represents the input source selected for the Print Test. One of the
following sources is displayed: Tray 1, Tray 2, Tray 3, or MP Feeder.
<input tray>
Feeding...
<input tray>
Canceling...
To Next Page
Loading...
