Lexmark W812 - Transfer Guide Assembly Removal

4-36 Service Manual
4022-XXX
Transfer Guide Assembly Removal
1. Remove the top cover.
2. Remove the fuser assembly.
3. Remove the transfer roller.
4. Remove the right cover.
5. Remove the upper card cage cover.
6. Remove the operator panel.
7. Remove the rear cover.
8. Remove the rear plate.
9. Remove the card cage cover.
10. Remove the controller card.
11. Disconnect the cables connecting to P19 and P26 engine card.
12. Remove the registration sensor cable from the clamps.
13. Disconnect the two high voltage power supply cables from the rear of the transfer
guide assembly.
14. Remove the screw securing the upper right of the transfer guide assembly to the
frame.
15. Remove the screw securing the right rear of the transfer guide assembly to the
frame.