3-20 Service Manual
4022-XXX
Clearing the Error Log
To clear the error log, select the Clear Log operation from the ERROR LOG menu. The
printer displays the following message.
Select Ye s to confirm that you really want to clear the log. The error log is cleared and
then the empty log is displayed as shown.
Select No to exit the Clear Log menu. Press Return or Stop to exit the Clear Log menu.
Configuration Mode
Note: Access is gained into the Configuration Menu Group using the Select and Return
POR key sequence. While the Configuration Menu Group is active, all host interfaces are
offline.
Clear Log
=Yes
1-000 2-000
3-000 4-000
Intermediate Menu, Printer
Setting or Printer Operation
Value List
Maint Cnt Value No selections exist for this operation. Pressing Select
initiates this operation. Go to “Viewing and Resetting
the Maintenance Page Count” on page 3-22.
Reset Maint Cnt Reset
For additional information regarding this operation, go to
“Viewing and Resetting the Maintenance Page
Count” on page 3-22.
REGISTRATION
The following printer settings are contained in the REGISTRATION menu. Go to “Setting
Printer Registration” on page 3-23 for a description of this operation.
Pressing Select in any of the following menus not only selects the currently displayed value
as the default, but also prints a ‘Quick Test’ page before returning to the prior level of the
menu.
This menu is not displayed if the printer is in demo mode.
Top Margin
Tray 1 Left Mar
Tray 2 Left Mar
Only displayed if Tray 2 is installed.
Tray 3 Left Mar
Only displayed if Tray 3 is installed.
To Next Page
Loading...
