Lexmark W812 - Optional 250-Sheet Pick Roller Removal; Optional 500-Sheet Pick Roller Removal

Repair Information 4-27
4022-XXX
Optional 250-Sheet Pick Roller Removal
1. Remove the optional 250 sheet feeder assembly from the printer.
2. Compress the roller (A and B) locks and slide rollers A and B away from the center.
3. Slide pick rollers (C and D) away from the center, then lift and remove.
Note: When installing pick rollers, note the orientation as shown in the illustration.
Note: When sliding rollers A and B back into position, press down on the separator pad
to allow clearance for the rollers.
Optional 500-Sheet Pick Roller Removal
1. Remove the optional 500-sheet feeder assembly from the printer.
2. Remove the pick rollers by pulling the rollers up as shown in the illustration.
Right
Front
A
B
C
D
Right
Front