Lexmark W812 - Right Cartridge Guide Assembly Removal; RIP Controller Card Removal

4-34 Service Manual
4022-XXX
Right Cartridge Guide Assembly Removal
1. Remove the transfer roller.
2. Remove the two screws which secure the right cartridge guide assembly.
3. Disconnect the cable from P29 on the engine card.
4. Remove the right cartridge guide assembly.
RIP Controller Card Removal
1. Remove the right side cover.
2. Remove the upper card cage cover.
3. Remove the outer metal card cage panel.
4. Remove the rear metal card cage panel.
5. Disconnect all cables and any installed features connected to the RIP controller
card.
6. Remove the screws securing the RIP controller card and slide the card toward the
rear of the printer, disconnecting it from the engine card.
7. Remove the RIP controller card by sliding the card completely out the rear of the
printer.
Note: Whenever a new RIP controller card is installed, make sure the configuration ID is
set. Go to “Configuration ID” on page 3-18.