3-4 Service Manual
4022-XXX
Print Tests
The Diagnostic Input Source PRINT TESTS may be used to verify that the printer can
print on media from each of the installed input sources. Each of the installed sources is
available as a selectable option within the PRINT TESTS menu. For each source, the
user has two choices:
• Single (print the Print Test page once),
• Continuous (continue printing the Print Test page until Return or Stop is pressed).
The content of the Print Test page varies depending on the media installed in the selected
input source. If a source is selected that contains paper (that is letter, legal, and so on),
then a page similar to the Quick Test page is printed. However, it does not contain the
Print Registration diamonds. If a source is selected which contains envelopes, then an
Envelope Print Test pattern is printed. This pattern only contains text, which consists of
continuous prints of each character in the selected symbol set.
If Continuous is selected, all sources printing with paper sizes print the same page
continuously until the test is stopped. If Continuous is selected for a source which
Par 1 Strobe Adj
Only displayed if a parallel
port is available using PCI
slot 1.
-4 to 6 (0)
Par 2 Strobe Adj
Only displayed if a parallel
port is available using PCI
slot 2.
-4 to 6 (0)
Par 3 Strobe Adj
Only displayed if a parallel
port is available using PCI
slot 3.
-4 to 6 (0)
ERROR LOG
Display Log Go to “Viewing the Error Log”
on page 3-19.
Clear Log Go to “Clearing the Error Log”
on page 3-20.
Ye s
No
EXIT DIAGNOSTICS
Go to “Exiting Diagnostic Mode” on page 3-1.
Top-level Menu
Intermediate Menu,
Printer Setting, or
Operation
Value List
To Next Page
Loading...
