Diagnostic Aids 3-3
4022-XXX
Input Tray Tests Feed Test Only installed paper sources are
displayed.
Tray 1
Tray 2
Tray 3
MP Feeder
Single
Continuous
For additional information, go to
“Input Tray Feed Test” on
page 3-13.
BASE SENSOR TEST
For additional
information, go to “Base
Sensor Test” on
page 3-14.
DEVICE TESTS
Only displayed if a flash or disk unit is installed.
Quick Disk Test
Only displayed when a
disk is installed.
Go to “Quick Disk Test” on
page 3-15.
Disk Test/Clean
Only displayed when a
disk is installed.
Go to “Disk Test/Clean” on
page 3-15.
Flash Test
Only displayed when an
optional flash memory is
installed which is not
defective.
Go to “Flash Test” on
page 3-16.
PRINTER SETUP
Defaults U.S.*
Non-U.S.
Page Count 0 to 9999999 (0)
Perm Page Count 0 to 9999999 (0)
Serial Number xxxxxxxx (printer serial number)
where x = A - Z, 0 - 9, ‘-’ or ‘’
Configuration ID 000000 to 999999
Edge to Edge Off*
On
Par S Strobe Adj
Only displayed if the
printer is configured with a
standard parallel port.
-4 to 6 (0)
Top-level Menu
Intermediate Menu,
Printer Setting, or
Operation
Value List
To Next Page
Loading...
