Diagnostic Aids 3-17
4022-XXX
Printer Setup
Defaults
The EP Defaults menu is used to restore each of the printer settings contained in the EP
SETUP menu to their factory default value.
To restore the EP SETUP settings to factory defaults, select Restore. To exit the menu
without restoring the settings to factory defaults, select Do Not Restore.
Setting the Page Count
The printer page count can be changed using the Diagnostics menus. This menu is used
by the CE to reset the Page Count setting whenever the engine card is replaced. The
engine card contains the printer NVRAM memory. When Page Count is selected from the
PRINTER SETUP menu, the current page count is displayed:
The leftmost digit (‘1’ in this example) blinks, indicating it is the first digit to be changed. To
change the value, press Menu until the value you want is displayed. Press Select to
move to the next digit. The next digit (‘2’ in this example) blinks. Continue modifying each
digit using this method. To skip a digit (that is and keep its current value), press Select.
When Select is pressed after the final digit (‘7’ in this example), the new page count is
stored in NVRAM.
Viewing the Permanent Page Count
The permanent page count setting cannot be modified using the operator panel. It can
only be viewed using the Diagnostics menus. When Permanent Page Count is selected,
the following screen is displayed.
Serial Number
The eight-digit serial number can be viewed and changed from this menu.
Page Count
=1234567*
Perm Page Count
=1234567*
To Next Page
Loading...
