1-18 Service Manual
4022-XXX
Guide End - Adjusts forward and backward to fit to different paper sizes. These
components hold paper at the specified positions forward and backward respectively.
The size of paper in the cassette must be transmitted to the printer control unit as a set
value by the dial paper size.
Plate Lift L Plate Lift R - Mounted at the end of the cassette, the plate lifts are pushed up
when the cassette is inserted into the printer.
Lift Plate - The force for pushing up the lift plate is supplied by the springs connected to
the plate lift. Pushing up the lift plate assures the contact between the supplied paper and
pick rolls.
Separator Pad - Applies the friction force to the lower side of paper preventing multiple
sheets from being picked simultaneously by the pick roll. This component is to be
replaced each 100,000 sheets.
Guide Paper L
Plate Lift L
Lift Plate
Separator Pad
Plate Lift R
Guide Paper R
Guide End
Front
Paper Tray/Cassette
Assembly
Lift Plate
Plate Lift
L and R
Front
To Next Page
Loading...
