Diagnostic Information 2-9
4022-XXX
961 Memory Error The RAM in slot 1 on the RIP board is bad. Replace the failing
RAM card.
962 Memory Error The RAM in slot 2 on the RIP board is bad. Replace the failing
RAM card.
964 Emulation Error A failure within the download emulation CRC which is
programmed into the RIP board. To resolve the problem, a
servicer may disable the download emulation by entering the
Configuration Menu and set the Download Emulation to
"Disabled." The download emulation may be reinstalled at that
point. If the problem persists, the download emulator may be
faulty and should be replaced.
975 Network Card The network port is unrecognizable. For printers equipped with
(standard) network circuitry on the RIP board, replace the RIP
board. For printers equipped with an optional network card,
replace the failing card.
976 Network Card An unrecoverable software error in the network port. For printers
equipped with (standard) network circuitry on the RIP board,
replace the RIP board. For printers equipped with an optional
network card, replace the failing card.
978 Network Card A bad checksum while programming the network port. For
printers equipped with (standard) network circuitry on the RIP
board, replace the RIP board. For printers equipped with an
optional network card, replace the failing card.
979 Network Card Flash parts failed while programming the network port. For
printers equipped with (standard) network circuitry on the RIP
board, replace the RIP board. For printers equipped with an
optional network card, replace the failing card.
980 Duplex Comm. A communication error occurred between the base printer and
the optional duplex unit. Check the installation of the duplex unit,
particularly the electrical connection. If installed correctly,
remove the duplex unit to see if the error message goes away
after rebooting. If the problem goes away, replace the duplex
unit. If the problem persists, replace the RIP board.
9xx
Code
Second Line
Message
Description/Action
To Next Page
Loading...
