Trackit Mk3 User Manual
80
FCC St a t em ent
This device com plies wit h Part 15 of t he FCC Rules. Operat ion is subj ect t o t he following t wo
conditions: (1) t his device m ay not cause harm ful int erference, and (2) t his device m ust accept
any int erference received, including int erference that m ay cause undesired operat ion.
NOTE: This equipm ent has been test ed and found to com ply wit h the lim it s for a Class B digit al de-
vice, pursuant t o Part 15 of t he FCC Rules. These lim it s are designed t o provide reasonable prot ec-
tion against harm ful interference in a residential installat ion. This equipm ent generat es, uses and
can radiate radio frequency energy and, if not inst alled and used in accordance wit h the
instruct ions, m ay cause harm ful int erference to radio com m unications. However, t here is no
guarantee t hat interference will not occur in a particular installat ion. I f this equipm ent does
cause harm ful int erference to radio or television reception, which can be det erm ined by turning
the equipm ent off and on, t he user is encouraged t o t ry t o correct the int erference by one or
m ore of t he following m easures:
• Reorient or relocat e t he receiving ant enna
• I ncrease t he separation between the equipm ent and receiver
• Connect the equipm ent int o an outlet on a circuit different from that to which the receiver
is connected
• Consult t he dealer or an experienced radio/ TV t echnician for help
I C Com plia nce
Operation is subject to the following t wo condit ions:
( 1) t his device m ay not cause harm ful int erference, and
(2) this device m ust accept any int erference received, including int erference that m ay cause unde-
sired operation.
This device has been designed t o operat e wit h an ant enna having a m axim um gain of 8dBi
dBi. Having a higher gain is st rictly prohibit ed per regulat ions of I ndustry Canada. The required
ant enna im pedance is 50 ohm s.
To reduce potential radio int erference to ot her users, t he ant enna t ype and it s gain should be
so chosen t hat the equivalent isot ropically radiated power (EI RP) is not m ore t han t hat
required for successful com m unicat ion.
The inst aller of t his radio equipm ent m ust ensure that t he ant enna is locat ed or pointed such
that it does not em it RF field in excess of Health Canada lim it s for the general population;
consult Safety Code 6, obtainable from Health Canada’s websit e
www .hc- sc.gc.ca/ rpb
La belling Re quir e m e n t s for End Pr oduct
For an end product using t he OEM Serial Port Adapt er or the OEM Bluet oot h Enabler there m ust
be a label cont aining, at least, t he following inform at ion:
Origina l ( OEMSPA3 3 i)
This device contains
FCC I D: PVH070201
3 r d Gene ra t ion ( OEMSPA3 3 2 i)
This device contains
FCC I D: PVH090202L
I C: 5325A- 090202L
4 t h Gene r a t ion ( OBS4 3 3 i)
This device contains
FCC I D: PVH0939
I C: 5325A- 0939
The label m ust be affixed on an exterior surface of t he end product such t hat it will be visible
upon inspect ion in com pliance wit h the m odular approval guidelines developed by t he FCC.
To Next Page
Loading...
