Page 56 of 76
Troubleshooting for Parallel:
Symptom Possible cause Action
BusLink monitoring:
Reason for last stop
Overvoltage • When seeing overvoltage, the
system stops at the same time.
The system needs re-powering
and In/Out signals must be
removed before next movement
Undervoltage • When seeing undervoltage, the
system stops at the same time.
The system needs re-powering
and In/Out signals must be
removed before next movement
For more information and easy set-up of BusLink, please follow this link to view the Quick
Guide for BusLink: http://www.linak.com/techline/?id3=2356
Be aware of Modbus actuator - please see the Modbus installation guide.
http://www.linak.com/techline/?id3=2363
To Next Page
Loading...
