4 Operation
Standard equipment
¾ Pull actuating lever (1) backwards.
Lowering the fork carriage
¾ Push actuating lever (1) forwards.
Tilting the lift mast forwards
¾ Push actuating lever (2) forwar
ds.
Tilting the lift mast backwards
.
¾ Pull actuating lever (2) backwards.
Operating attachments
Attachments can be fitted to the truck as spe-
cial equipment (e.g. sideshift, clamps, fork
positioner etc.). Refer to the working pressure
and operating instructions for the attachment.
One or two additional actuating levers are fit-
ted for operating the attachments.
WARNING
For attachments that perform a clamping operation
(e.g. bale clamp), a lockable lever must be used.
If your truck is not fitted with this equipment, please
contact your authorised dealer.
NOTE
Before fitting an attachment, a depressurisa-
tion circuit (special equipment) can be used to
depressurise the hydraulic system for the au-
xiliary hydraulics so that the connection on the
attachment can be affixed to the connection
on the fork carriage.
¾ Switch off the engine.
¾ Switch on the ignition.
¾ Operate the actuating lever for the respec-
tive auxiliary hydraulics several times.
¾ Unscrew the union nuts on the fork carriage.
¾ Screw on hoses for attachment or connect
plug connectors.
54 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
