LinMot
Table of Contents
User Manual V1.01 iii
5.10 Error Inspector _______________________________________ 5-22
5.10.1 Operational elements of the Error Inspectors___________________ 5-22
5.11 Tutorial A: First Steps ________________________________ 5-24
5.11.1 Commissioning example __________________________________ 5-24
5.12 Tutorial B: Operating the Oscilloscope __________________ 5-25
5.12.1 Creating a curve_________________________________________ 5-25
5.12.2 Configuring the electronic unit _____________________________ 5-25
5.12.3 Oscilloscope configuration for the recording of the position set value5-26
5.12.4 Oscilloscope configuration for the following error monitoring _____ 5-27
5.12.5 Final remark____________________________________________ 5-28
5.13 Tutorial C: Generating reference curves _________________ 5-29
5.13.1 "Linear Out" curve_______________________________________ 5-30
5.13.2 "Hold" curve ___________________________________________ 5-32
5.13.3 "Jump Back" curve ______________________________________ 5-33
5.13.4 Saving curves___________________________________________ 5-34
5.13.5 Merging curves _________________________________________ 5-34
5.13.6 Writing curves to the electronic unit _________________________ 5-36
5.14 Tutorial D: Defining curves with Excel __________________ 5-37
6. Parameters __________________________________________ 6-1
7. Service ______________________________________________ 7-1
To Next Page
Loading...
