LiteOn EVO 6800 Series - Page 194

194
1 : Enabled
Switches between Local and Remote Operation but only during drive stop. Switching is not
possible when entering a Run command. When Local mode is selected, the LED indicator on
the LO/RE will light up.
WARNING! Pay attention to the following situations when b1-05 (Run Command Action after Switch ) is set to 1
(Accept Active Run Command at the New Source).
If a run command at the new source is active, the drive will accept it and run the motor immediately right after
switching from the old source to the new source. Clear all personnel from the electrical connections and the running
machinery prior to switching command sources. Failure to comply could cause serious injury.
Refer to Table 6.22 for the relationship between o2- 00 and b1- 05.
Table 6.22 Relationship between LO/RE and b1-05
o2-00
b1-05
Switch from Local to Remote
Switch from Remote to Local
0
0
Not possible to switch
Not possible to switch
1
Not possible to switch
Not possible to switch
1
0
The drive will not run until a new Run
command is enterd.
Not possible to run
1
If a Run command is entered, the drive
will start running as soon as the LO/RE
key is pressed.
Not possible to run
 o2-01 STOP Key Function Selection
Determines if the STOP key on the keypad will stop the drive when Remote is selected as the
command source.
No.
Name
Setting Range
Default
o2-01
STOP Key Function Selection
0, 1
1
0 : Disabled
1 : Enabled
The STOP key always stops drive operation even if the command source is not set to the
keypad. To restart the drive,cycle the Run command if the drive has been stopped by pressing
the STOP key.
 o2-02 Retain
 o2-03 Drive Capacity Selection
Set this parameter after replacing the terminal block or drive modules.