LiteOn EVO 6800 Series - Page 76

76
0 : Run command disabled during Programming
A Run command is not accepted when the keypad is being used to edit parameters in
Programming Mode.
1 : Run command enabled during Programming
A Run command is accepted when the keypad is being used to edit parameters in
Programming Mode.
2 : Prohibit programming during run
The programming mode cannot be displayed during run except for monitoring parameter
Group U.
 b1- 07 Frequency Command Selection 2
Refer to the details of b1-00 (Frequency Command Selection 1). This parameter is only enabled
while E1-00 to 07 is set to 4 and the DIP switch is set to OFF.
No.
Name
Setting Range
Default
b1-07
Frequency Command Selection 2
0 to 4
0
0 : Keypad
1 : Control Circuit Terminal (Analog Input)
2 : Terminal UP/DOWN
3 : Modbus Communication
4 : Pulse Train Input
 b1- 08 Run Command Selection 2
Refer to the details of b1-01 (Run Command Selection 1). Enabled while E1-00 to 07 is set to 4
and the DIP switch is set to OFF
No.
Name
Setting Range
Default
b1-08
Run Command Selection 2
0 to 2
0
0 : Keypad
1 : Control Circuit Terminal (Sequence Control Input)
2 : Modbus Communication
 b1- 09 Frequency superposition Selection
No.
Name
Setting Range
Default
b1-09
Frequency superposition Selection
0,1
0
0 ：Disabled