70 CHAPTER 8: OPERATION
TRYTON 107/112
2.2. Function keys F1 - F4
These keys are located right below the display. The functions attributed to them are indicated on the display
by icons.
As the operator advances in the handling, the functions of the keys are automatically reattributed to
correspond to the circumstance and availability of the bar feed system.
The risk of error in handling is therefore virtually reduced given that the proposed functions always
correspond to the circumstance and availability of the bar feed system.
2.3. Left/right, up/down keys
These keys allow entering values (bar stock diameter, part length, etc.) or parameters.
When a list of parameters is submitted, the left/right and up/down keys make it possible to select them.
2.4. Emergency stop button
When a dangerous situation arises, pressing the emergency stop switch interrupts immediately all bar feed
system and lathe functions (if interface is wired accordingly).
To cancel the alarm, release the switch by rotating its red knob counter-clockwise, then press [STOP].
2.5. STOP key
The STOP key allows interrupting the sequence under way.
Important: the automatic cycle of the lathe must first be interrupted.
By pressing the STOP key, allows to exit the setting mode, regardless of the level reached, and to return
to the work screen.
The STOP key is not an emergency button, and cannot be interpreted as such. For
emergency cases, always use the emergency button located on the top of the remote
control.
To Next Page
Loading...
