CHAPTER 8: OPERATION 71
TRYTON 107/112
3. SET UP
Please read the safety precautions described at the beginning of this manual before
handling the following devices.
When machining tubes, it is recommended to plug the rear end of the material so that the
oil from the bar feeder and the cutting fluid do not mix.
All handling, optional accessories and settings required by the bar feed system to carry out a specific job
are part of the set-up.
A few simple operations are necessary to prepare the device to handle another range of diameters.
The set-up must be modified when following parameters change:
1) Bar stock diameter
2) Bar stock shape
3) Part length
Before any operation, stop the lathe after machining a workpiece !
To modify any parameter, the bar feed system must bee in STOP mod.
To check a parameter or validate a new parameter, maintain the key [ENTER].
To Next Page
Loading...
