CHAPTER 8: OPERATION 89
TRYTON 107/112
8. When mobile vice reaches the end-stop, the cam separates the ball-bearings and the jaws grip
the remnant.
9. The connector withdraws to the end-stop and extracts the remnant from the barfeed collet.
10. The barrel is then indexed and it positions the next bar in the axis of the pusher and the spindle.
The loading cycle restarts.
9. POWERING DOWN
Before handling the bar feeder, stop the lathe at the
end of part cycle !
When powering off the barfeed, make sure the pusher is in reference
position, table in lower position, and no bar stock is present in the
guiding element.
To power down, turn the switch to the left, to the 0 off position.
To Next Page
Loading...
