CHAPTER 8: OPERATION 75
TRYTON 107/112
4.5. Top-cut position
Only for CNC lathe type
During the loading cycle, the bar is automatically loaded and positioned into the spindle, outside the
clamping device of the lathe (chuck or actuator).
This positioning corresponds to a value (Z) programmed by the operator, which is equal to the distance
between the measuring cell and the position of the material in the lathe clamping device.
With this system, the setting is the same for any bar length.
4.5.1. Setting
Before handling the barfeeder, stop the lathe at the end of part cycle !
1) Press the [STOP] key.
2) Press the [MENNU] key.
The following text is displayed :
3) Press the key corresponding to the [PAGE DOWN] icon.
The following text is displayed :
4) Press the key corresponding to the [ENTER] icon.
The following text is displayed :
5) Enter the new value with the numerical keys
6) To validate the new TOP CUT position, hold on [ENTER] key until the icon disappears (about. 2 sec.).
7) To exit adjustment mode, to press the [MENU] or [STOP] key.
PARAMETERS RELATED TO
START-UP
POSITION OF THE CUT OFF
(TOP CUT) **** MM
To Next Page
Loading...
