12A-19
FUEL MIXTURE
Exhaust manifold
K7J, and 710
12A
REMOVAL
Mount the vehicle on a two post lift.
Remove the heat shield mountings (1).
Disconnect the oxygen sensor connector.
Remove:
- the two exhaust downpipe mountings (2),
- the exhaust manifold - cylinder head mountings,
- the exhaust manifold.
REFITTING
Always replace all seals that have been removed.
Refit the new seal on the exhaust manifold.
Tightening torquesm
exhaust manifold moun-
ting nuts
2.5 daNm
exhaust downpipe
mounting studs
0.7 daNm
exhaust downpipe
mounting nuts
2.1 daNm
108425
11
108427
109399
WARNING
You must replace the exhaust bushing between
the exhaust manifold and the catalytic converter.
2
To Next Page
Loading...