10A-5
ENGINE AND LOWER ENGINE ASSEMBLY
Engine/gearbox assembly
L90, and K7J, and 710
10A
REMOVAL
Place the vehicle on a two-post lift.
Essential special tooling
Mot. 1202-01 Clip pliers for cooling
system hose clips
(large model)
Mot. 1202-02 Clip pliers for cooling
system hose clips
(small model)
Mot. 1448 Remote operation
pliers for cooling sys-
tem hose clips
Mot. 1453 Multiple-adjusting
engine mounting sup-
port with retaining
straps
Mot. 1159-03 Engine mounting on
right-hand side mem-
ber for operations not
requiring removal of
the engine
Mot. 1390 Support for removing
and refitting the engine
and gearbox assembly
Tav. 1747 Threaded rods for
removing the sub-
frame
Essential equipment
filling station
Tightening torquesm
gearbox rubber moun-
ting mounting bolts
10.5 daNm
gearbox cover moun-
ting nut on the gearbox
rubber mounting
6.2 daNm
sub-frame mounting
bolts
10.5 daNm
sub-frame tie-rod upper
mounting bolts
2.1 daNm
sub-frame tie-rod lower
mounting bolts
6.2 daNm
steering rack mounting
bolts
10.5 daNm
shock absorber base
bolts
10,5 daNm
brake calliper mounting
bolts
10.5 daNm
track rod end nuts 3.7 daNm
engine tie-bar mounting
bolts
10.5 daNm
wheel bolts 10.5 daNm
Note:
The « engine and gearbox » assembly can be
removed by removing the « engine and gearbox/
driveshafts/half-axles/sub-frame » assembly.
IMPORTANT
During this operation, use a strap to secure the
vehicle to the lift to prevent it from becoming
unbalanced.
For the strap fitting procedure, (see 02A, Lifting
equipment, Underbody lift).
Tightening torquesm
To Next Page
Loading...